Page 3 of 4

Re: 2017 F-Pace 35t Prestige build

Posted: Sat Feb 08, 2020 4:44 pm
by Bob a
Very smart.

Re: 2017 F-Pace 35t Prestige build

Posted: Sun Feb 09, 2020 8:49 pm
by Danke
Installed the QuickSilver exhaust system today.

The install was very simple. Only one bolt and two hangers on each side. Took 45 minutes total. It sounds great.

However, the set screws on the exhaust tips would not go in far enough to make contact with the exhaust pipe. It seems as if the welded on nut is off-center with the hole on the exhaust pipe. 😑

I've contacted QuickSilver and will await their response.

Photo Feb 09, 3 21 37 PM.jpg


Re: 2017 F-Pace 35t Prestige build

Posted: Mon Feb 10, 2020 1:48 pm
by Danke
Update: QuickSilver is sending out new tips to me today, free of charge :)

Re: 2017 F-Pace 35t Prestige build

Posted: Mon Feb 10, 2020 3:11 pm
by Bob a
Great service

Re: 2017 F-Pace 35t Prestige build

Posted: Wed Feb 12, 2020 12:16 am
by Danke
Springs were delivered today :D

Image

Re: 2017 F-Pace 35t Prestige build

Posted: Thu Feb 13, 2020 8:49 pm
by Danke
H&R springs installed today with a 1.2" drop all around. Exhaust tips added today too.

Image

Image

Re: 2017 F-Pace 35t Prestige build

Posted: Fri Feb 14, 2020 12:53 pm
by SRE
Are you going to paint/colour code all the Tupperware (the spark finish plastic) cladding on the doors, also the lower part of the rear bumper?

Re: 2017 F-Pace 35t Prestige build

Posted: Fri Feb 14, 2020 1:28 pm
by Bob a
Looking very smart. Well done

Re: 2017 F-Pace 35t Prestige build

Posted: Fri Feb 14, 2020 10:55 pm
by Danke
SRE wrote:
Fri Feb 14, 2020 12:53 pm
Are you going to paint/colour code all the Tupperware (the spark finish plastic) cladding on the doors, also the lower part of the rear bumper?
I'm going to get a quote to do it. Not sure what to expect the cost to be or what would be fair. What do you think it should cost? It would definitely look better.

Re: 2017 F-Pace 35t Prestige build

Posted: Sat Feb 15, 2020 10:55 am
by SRE
Colour code the door cladding circa €350.
The rear bumper and the lower part of both rear panels €400.